how to connect garden hose to pvc pipe

A non-professional person may think of the method: after hot-melting the two ends of the two flexible water pipes, stick them together, and the effect of sealing and connection can be achieved after drying, but the connection is likely to be damaged due to water pressure. is too large, causing disconnection.

There is another method estimated to be used by many people, that is to take a PVC pipe with the inner diameter of the hose, apply sealant on the outside of the PVC pipe, and then put two hoses on the outside of the PVC pipe, and wait until it is firm. The effect of connection can be achieved. Although this method is beautiful and beautiful, it will leak after a long time due to water pressure.

The detailed steps to connect the pvc pipe are as follows:

Step 1: Cut the cutout on the side of the hose flat. This is mainly because the gap is smoother and more beautiful when the two water pipes are connected.

Step 2: Clean the dust inside the two hose connections. This step is mainly to prevent the sealing of the adhesive material and the hose from voids and sand particles.

Step 3: Take a PVC pipe with the inner diameter of the rubber soft water pipe. The length is preferably about ten centimeters, neither too short nor too long; if it is too short, the bonding will not be firm, and if it is too long, it will be inconvenient to turn or collect the tube.

Step 4: Coat the outside of the PVC pipe with adhesive material.

Step 5: Apply adhesive material to the inside of the hose. Try to apply as little as possible on the internal test, and remove the excess adhesive material.

Remarks: The fourth step and the fifth step should be done at the same time, and the fifth step cannot be done after the adhesive material in the fourth step is completely dry.

Step 6: Insert the PVC pipe inside the hose. The PVC pipe inserted into the inside of the hose should be 1/2.

Step 7: Coat the inner side of the hose at the other end and the outer side of the PVC pipe with adhesive material.

Step 8: Slowly insert the soft water pipe into the outside of the PVC pipe. Remove excess adhesive material.

Remarks: At this time, the connection of the hose is basically completed, but the water pressure is too high. If things go on like this, the hose at the connection may also fall off, and we still need to do consolidation steps.

Step Nine:

Method 1: Fasten both ends of the connected hose with clamps. This is mainly because the water pressure is too high, and the extrusion of the PVC pipe causes water leakage.

Method 2: Fix the outer side of the hose tightly with a steel wire. In fact, this method is more ideal than method 1. If you use a card, you can’t tighten the hose in the middle, but if the steel wire is tightened, it will look like there is a scratch in the middle of the hose, which is equivalent to a concave shape, so that you can completely prevent water leakage. Hosting this phenomenon occurs.